Bracelets of Suede Cords, Buttons and Beads

Here are a couple of maybe a dozen things I’ve made over the past few weeks

First, in my stash I found some beads that match this turquoise suede cord. But I had trouble finding a button to work. A pearl button was too foo foo for the suede. But a white plastic button was too plain to match the silver, white and blue beads.

So.

I had to abandon my stash and look for a button in the store! Fortunately I found a pair of  transparent buttons with silver swirly curly cues on top. It turned out to be the perfect match.

The bracelet is easy to make with simple overhand knots.

First use a cord that will loosely wrap around your wrist twice with four or five inches to spare. Fold the cord in half and slide the button to the halfway point.

Tie one overhand knot at the base of the button. keep it loose until you can scooch it up close to the button, then gently pull each cord evenly to tighten it.  Next I threaded one bead on both cords (the silver and white) and then the next four buttons went on one of the cords and the final silver and white again went on both cords.

Then I wrapped it around my wrist and tied another overhand knot (keeping it loose until I was sure it was in the right place) and moved down an inch or so to leave a gap before tying the last knot. The gap is so the button can be used as a fastener.

Next.

I didn’t go looking for it per se, but while I was on the button aisle, I found some Organics* Elements buttons made of coconut. There were two square buttons with four holes, one gold and one sage green. The gold button matched a hank of gold suede cord from my stash. And coincidentally I had some wood beads that exactly matched. I haven’t found the right cord for the green button yet.

I tied the button on the cord with an “x” stitch through the four holes and tied an overhand knot at the base of the button. Then I threaded two wood buttons on one of the cords.

I used the other cord to make a couple of half-hitch knots to anchor the beads and then did the same with two more beads.

And because I didn’t want a just a beaded bracelet, I made a series of half-hitch knots, keeping them tight next to each other. Doing a series of half-hitch knots will automatically create a spiral in your cord.

It’s just like when you row on only one side of the boat.  You end up going in circles.

Then I threaded on two more sets of beads.

I was a little short of where I wanted it to end, so I made another half-hitch spiral section to make it long enough to go around my wrist.

I anchored it all with an overhand knot; skipped about an inch, and tied another knot, leaving room for the button.

I tied the knots really tight and cut the ends about an inch away from the knot. I want to see how they hold before I trim it too short. And while I could add glue to the knot, G-S Hypo Cement is recommended for this, I haven’t glued it yet.

I’ve worn both bracelets for several days. The knots are tight. So far, I haven’t felt the need to undo them and make them into something else.

Yet.

I love bracelets. I’ve got more to show you over the next few posts.

Jan

P.S. *If you go to the button website you’ll see it says Organic Elements,  but the button card specifically says organics (plural) elements. Organics is trademarked. The card has graphics I haven’t seen before which makes me think they might be changing their branding. I couldn’t find my specific buttons online anywhere.

 

Turkish Flat Weave Part II

I’ve figured out this Turkish Flat Weave beaded bracelet.

How ’bout them apples?

It was an easy process, but with the small beads all the same, my first attempts were a bit twisted. (See my previous post and you’ll know what I’m talking about.)

So I picked out larger beads and I threaded them on the cord in an A B pattern. I wanted to use that checkered wooden button so I picked the yellow and blue with the pink cord. I bought the cord in multi pack and the description was on the wrapper and not on the spools, so I’m not sure of the weight. Based on the .o5 inch blue cord below, it might be a .01 cord?

Using the A B pattern of beads, it was very easy to keep my place. Every other “row” connected a blue bead, then a yellow bead. Easy peasy.

Then I had this red and gold button I wanted to use so I found some red and gold beads and decided on a black waxed cotton cord. Again, easy to keep my place.

The white bracelet was made with nylon cord that’s used for Roman shades and other decorator window treatments. The bracelet is all white, but I created the A B pattern with white beads and clear beads. I used a vintage cuff link button to close this one.

Then I wanted to use the green stripey beads but I didn’t have enough of them to go all the way around so I added three different green beads to make that row long enough.

I used a toggle clasp for this one. I’m not a fan of toggles. I’ve had a few fall off my wrist, but this one is small enough I think it will stay on.

Then I wanted to play with making a wider bracelet so I started with larger cord. This is .05 inch nylon cord. I bought this spool on clearance awhile back intending to crochet a little purse with it, but that has yet to happen.

I had a tube of 2mm multi-colored blue Czech beads and I sorted them into a pattern that I liked. I also changed the single crochet stitch to a half-double crochet.

The pattern has two beads on one side and one bead on the other. And look how well that flower button matches.

Then I got brave enough to try something without the A B pattern thing going on and I made the pink one.

I wasn’t bold enough to use all the same beads, but I used pairs of random pinks and purples. I also downsized to a Size F crochet hook.

And then I found a teeny tiny pink button to use as a clasp. I put a single pink bead on top.

Then while sorting my beads to put them away I found a strand of black and brown glass beads I had to use. I matched them with simple round glass beads and used the 1mm rattail cord.

I stuck with the smaller hook (F) and kept my stitches tight.  And look at that cool chevron pattern that emerged.  It had been there all along but with the smaller cord and looser stitches it wasn’t obvious in the other bracelets.

Now I’m ready to make over the first two bracelets I made all twisty. They’re in a very special place and as soon as I can remember where that is, I’ll get right on it.

I have some beads I really want to use but the bead hole is very small.  I can use a reamer to smooth out holes that are a bit tight, but some are out of the questions. Does anyone know if I could drill out a bigger hole? I think I have a set of teeny tiny drill bits. It probably depends on the type of material the bead is made of. Any advice?

I might use two strands of cord. String the beads on a skinny little cord and align it with the larger cord I want to use. Then I’ll crochet them together with the beads on the smaller cord that’s practically invisible while the bracelet is made out of the larger more visible cord.

If you’re interested in doing this here’s the video tutorial where I found it. Her bracelets are much smaller and tidier than mine, but I’m still learning.  My goal was to make a beaded bracelet and I achieved that. I’m not very good at following instructions.

 

Oh, I couldn’t find C-Lon cord.  Not at JoAnn’s or Michael’s, which are my two options. I used cord I have on hand and picked out some other options. I have some bamboo I want to use, but it’s pretty thick.  I’ll have to find beads with large holes for that one, or use the double strand technique I mentioned.

Anyhoo.

If you make some of these (it’s addictive!  Like crafters need another addiction!) I’d love to see what you come up with and how you did it. It’s fast and simple once you pick out your beads.  I can make one in about a half-hour and then I have to decide on what kind of clasp I want.

I’ve shown you mine, now you show me yours!

Jan

 

 

 

 

 

To Do: A Pillow, But Not a Bracelet

I had a to do list today, and I didn’t get through it because I got distracted. Everything on my list was something I need to finish. I wasn’t going to start anything new.

But then I did.

Like this bracelet.

It was not even on my radar until I got an email from Creative Bug with a video tutorial on how to make one.  It’s crocheted and it’s called a Turkish Flat Weave. It’s not hard, but using hemp was not the best choice for my first attempt. The stiffness of the cord was kind of cranky. And like I found out with a previous project, it’s hard to see what’s what in the black yarn, or cord.

So I picked out some supplies for another one.

I went with the cream-colored number 8 pearl cotton thread and the bright beads.

The parts I got right are really nice.  But it’s twisted where I didn’t flip it the right way. If you watch the video you’ll know what I mean.  Once I get the hang of it I’ll unstring this and make it over.

By the way, if you can crochet, this is a very quick project. I started the second one at 10:30 and 45 minutes later I was working on the closure.

This pillow was on my to do list. This is not the pillow I set out to make but it’s what the fabric wanted to be. Anybody else have projects like that?

I made the pillow with a couple of decorator samples.

The floral with the owl is linen and the animal print is polyester. I have another piece that I think is drapery silk that will go on the back.

If you look close you’ll see my navy blue basting stitches. I haven’t decided exactly how I’ll attach the applique. If I have thread that exactly matches the pink I may quilt it down first before I secure the edges.

It’s going to be a pillow cover for a 16 or 18 inch square pillow. Since I don’t have another sample in this same color family this is all there is. The back piece is smaller than the front, so I’m hoping to manipulate it enough to manage a concealed zipper on one of the edges.

I have nothing this yummy pink will go with so I’ll probably sell it. It’s going to be amazing if you can use this almost dusty pink.

I have other decorator samples and I’m sure some of them will want to become the pillow I planned to make first.

How’s your to do list coming? Hope your day is swell!

Jan

One Hundred Items Listed on Etsy

I listed item number 100 a few minutes ago. Three more bracelets took me to that milestone.

There’s this blue paisley crocheted bracelet with a red and gold button.

 

This blue Infinity style features a large mother of pearl button on the top and a small blue vintage button on the back to fasten it.

 

This 4x Wrap Bracelet is significantly repurposed.  Instead of using cotton cord for piping, this bracelet us made with a discarded USB computer cable.

My little felt falling leaves bobby pins have been featured in two treasuries.

I hope that means I’ll sell them.

Or maybe someone would prefer Candy Corn Bobby Pins.

Locals can contact me to knock off the shipping for pick up.

I have a couple dozen more items photographed and in line to list. I’m researching Polaroid Land Cameras, Glass Insulators from 1893, a Paul Revere Reproduction silver pitcher, a couple of Italian hammered aluminum ice buckets, and a very cool three-in-one convertible handbag from 1957.  Very Mad Men-ish.

Any comments?

Jan